37
Step 28
Tape four pieces of card stock to the engine nacelle. Align
the card stock so the ends align with the front edge of the
firewall. Align the length so it is aligned with the raised
areas of the nacelle.
Step 29
Slide the cowling onto the nacelle and align the
opening in the dummy engine with the propeller adapter
of the engine.
Step 30
Drill four locations for the mounting screws using a
1/16-inch (1.5mm) drill bit. Drill the holes centered
in the card stock and roughly 1/8-inch (3mm) back
from the end of the template to guarantee drilling into
the hardwoood positioned behind the raised areas of
the nacelle.
Step 31
Apply a few drops of thin CA to each of the holes drilled
in the previous step. This will help harden the wood,
making the screws more secure in their placement.
Section 6: Glow Engine Installation
To Next Page