38
Step 32
Secure the cowling to the engine nacelle using four
#2 x 1/2-inch sheet metal screws.
Step 33
Cut an opening in the bottom of the cowling to the
dimensions shown to allow for cooling air to pass through
the cowl and over the engine.
Step 34
Cut the necessary openings in the cowling for the muffler,
glow plug and fuel dot. Attach the propeller using a scale
propeller nut.
Step 35
Repeat Steps 1 through 34 for the remaining engine
installation.
Section 6: Glow Engine Installation
To Next Page