33
– Turn off the switch to “OFF” position, press down the emergency disconnect switch, pull out
the battery plug, and take off the key.
– Fold up
7.7 Loading
Procedure:
– Drive the truck carefully up to the loads.
– Adjust fork height to make the forks are in the tray.
– Raise the loads several centimeters to make sure if the loads are firm.
– Travel the truck off the area.
– Drop the load to lower position.
7.8 Unloading
Procedure:
– Approach the deposit area.
– Raise the loads to correct height.
– Travel forward, put the load on the unloading position and then stop.
– Make sure the loads are right above, drop the forks slowly until the forks are out of the load.
To Next Page
Loading...
