Hanna Instruments HI931 - ISE Measurement and Calibration; ISE Mode Display and Options

9-3
ISE MODE
By pressing from the main screen, the Titrator can be switched to Titrator, pH, mV or ISE modes.
One Analog Board
Switches to Titrator mode.
Switches to pH mode.
Switches to mV mode.
Switches to ISE mode.
9.1. DISPLAY
The ISE screen is shown below.
ISE Mode option keys:
The General Options screen gives access to options that are not directly related to the measurement process (see
General Options section).
Stores the current concentration reading (see Manual Logging section).
or
Starts the ISE interval log (see Interval Logging section).
Enter the ISE calibration screen (see ISE Calibration section).
Enter the ISE setup screen. Parameters are associated with ISE measurements and calibration.
Allows the user to switch between the available measurement modes: Titrator, pH, mV and ISE mode.