2.2. SAFETY MEASURES
The following safety measures must be followed:
1. Never connect or disconnect the pump assembly with the titrator turned on.
2. Verify that the burette and the attached tubing are assembled correctly (see Maintenance, Peripherals, Burette Maintenance
for more details).
3. Always check that the titrant bottle and the titration beaker are on a flat surface.
4. Always wipe up spills and splashes immediately.
5. Avoid the following environmental working conditions:
• Severe vibrations
• Direct sunlight
• Atmospheric relative humidity above 95% non-condensing
• Environment temperatures below 10°C and above 40°C
• Explosion hazards
6. Have the titrator serviced only by qualified service personnel.
2.3. INSTALLATION
2.3.1. TITRATOR FRONT VIEW
To Next Page
Loading...
