9.2.3. ISOPOTENTIAL POINT (TEMPERATURE COMPENSATION)
Option: 1.00 E
-2
to 1.00 E
+5
ppm
This option allows the user to set an isopotential point for the selected electrode when temperature compensation is enabled. The
isopotential point is edited in ppm units only. The isopotential point will vary for different electrodes, if measurements are going to be
made at several temperatures, the value should be entered if it is known.
9.2.4. EDIT CUSTOM STANDARDS
Option: Up to five
• Use the and keys to select the standard.
• Press to delete the standard.
• Press to edit the selected custom standard; use the numeric keys to edit the standard.
To Next Page
Loading...
