Hansa C13 - Shutdown procedure

Hansa C13 O&M Manual - OM-007 Revision H 21/10/19
© Hansa Chippers 2019
9
To engage the belt drive, slowly
rotate the engagement handle
clockwise until it comes to a stop.
This must be done slowly to allow
the cutting rotor to pick up speed;
otherwise the engine may stall.
WARNING! Do NOT disengage the belt drive with the chipper running at full revs, as this will cause friction and vibration
on the belt drive.
Shutdown procedure
Turn the throttle lever to the “min” position and
wait for the rotor to slow down.
Disengage the belt drive by rotating the
engagement handle counter clock-wise until it
comes to a stop.
Turn the engine switch to “off” position.
5
1
2
3
Throttle
lever (“min”
position)