4. Remove and replace bearing.
5. When replacing the pulley ensure the rotor pulley is lined up to the engine pulley with a straight edge. Ensure the grub
screws are tightened evenly so the pulley is tightened evenly.
6. The gap between the end of the sensor and the sensing plate should be approximately 3 mm. Adjust the sensor
accordingly. If it is set further away, then the sensor may not work properly and therefore the AFC will not work.
Replacing rotor bearing on inlet chute side of rotor:
It is recommended to have this bearing replaced by a specialist Hansa dealer.
To Next Page
Loading...
