Hansa C65 O&M Manual – OM-028 First Release 4/05/2021
© Hansa Chippers 2021
To shut the machine down, move the throttle control
lever to the idle position (lowest position).
Once the engine has been given time to slow down to
idle speed (about 10-15 seconds), disengage the rotor by
winding the engagement handle in the anti-clockwise
direction until the handle comes to a stop.
WARNING! Only engage and disengage the rotor at
idle speed otherwise excessive vibration and belt friction
may cause damage.
Allow the engine to cool down by running at idle for at
least 1 – 2 minutes before shutting down. Turn the
ignition key anti-clockwise into the off position to shut
the chipper down.
WARNING! The heavy rotor will continue to turn for
some time after the engine has been shut down. Do not
open the rotor housing cover until the engine and cutting
disk have completely stopped and the rotor is
disengaged.
To Next Page
Loading...
