Hansa C65 - Grease Points; General Grease Points

Hansa C65 O&M Manual – OM-028 First Release 4/05/2021
© Hansa Chippers 2021
27
Maintenance & service intervals
Maintenance interval - service hours
10 or
50 or
100
250
500
1000
3000
Yearly
As req.
Service
Daily
Weekly
Drive belts tension – initial
check
Initial
Engine oil level – check
•
Cooling air duct screen –
check/clean
•
Air cleaner element – clean
•
•
General grease points (see
section in manual “General grease
points” or weekly service checks
label on housing wall)
•
Knives– check, sharpen or
replace
•
•
Tires & rims – check
•
Spring mounting – check U
bolts
•
Brake fluid - check
•
Drive belts tension -
check/adjust
•
Hydraulic system – check
•
Engine fan belt – check
•
Engine oil & filter – change
•
•
Hydraulic oil filter - replace
•
Battery electrolyte level &
terminals - check
•
Engine fuel filter – replace
•
Outlet chute – remove & clean
swivel
•
Feed roller tension springs -
replace
•
•
Anvil – check knife clearance
and bolt torque
•
•
Hydraulic filter – replace
•
Grease engine output shaft –
Hayes coupling
•
Air cleaner element – replace
•
Feed roller teeth – sharpen
•
•
Hydraulic oil – replace
•
Engine fan belt - replace
•
Engine – Valve clearances (refer
to Deutz service manual)
•
Engine – 3000-hour service by
authorised Deutz specialist
(refer to Deutz service manual)
•
Nuts & bolts – check torque &
replace if worn
•
Battery – replace
•
Drive belts – replace
•
Knives – replace
•
Anvil – replace
•
Hazard labels – replace
•