Hantek 1832C - 3.3 Inductance measurement; 3.4 Impedance measurement

17
1. Press the power key to start the instrument.
2. Press the [AUTO/R/C/L/Z] key until Ls/Lp is displayed on the interface which means to select
inductance measurement.
3. Insert the inductor into the test notch, or choose the appropriate test accessories (rubber plug -
alligator clip, Kelvin test fixture, etc.) and connect it with the measured inductor.
4. Press the [FREQ] key to select the desired test frequency, press [LEVEL] to select the desired
level.
5. Read the measurement results from the screen.
3.4 Impedance measurement
1. Press the power key to start the instrument.
2. Press the [AUTO/R/C/L/Z] key until Z is displayed on the interface which means to select
impedance measurement.
3. Insert the impeder into the test notch, or choose the appropriate test accessories (rubber plug -
alligator clip, Kelvin test fixture, etc.) and connect it with the measured impeder.
4. Press the [FREQ] key to select the desired test frequency, press [LEVEL] to select the desired
level.
5. Read the measurement results from the screen.