1
Safety
Review the following safety precautions carefully before operate the device to avoid any
personal injuries or damages to the device and any products connected to it. To avoid potential
hazards use the device as specified by this user’s guide only.
Only professionally authorized personnel can perform maintenance.
Do not run the product when the outer cover or panel is open.
Do not operate with suspected failures. If suspected damage occurs with the device, have
it inspected by qualified service personnel before further operations.
Do not operate in wet/damp conditions.
Do not use in explosive environments
Keep product surfaces clean and dry.
Security warning: One should abide by the relevant terms in the manual regarding safety or
injury to human body or damages to the product, as well as operation or environment which
may result in test failure.
Safety Guidelines
To make sure safe use of equipment, follow these guidelines:
The instrument is suitable for indoor use and an altitude of less than 2,000 meters. In case of
short-term outdoor use, prevent it from direct sunlight, water, electromagnetic radiation, dust,
etc.
Before the use, please read and understand the warning and safety information mentioned in
this manual.
Use the instrument according to the function specified in the manual.
If the component needs measurement, make sure the circuit is turned off and all capacitors in
the circuit are discharged before the measurement.
Before the measurement, components such as capacitors shall be discharged.
The lithium battery of 18650 or Type C-USB is used to provide power for the instrument. It
can be charged with Type C-USB port.
Safety Symbols
Warning: Remind the user to follow the operating procedures in the manual.
To Next Page
Loading...
Need help?
General
