General Care and Cleaning
General Care
Do not put or leave the device in a place where the LCD display will be exposed to direct
sunlight for long periods of time.
Note: To avoid damage to the oscilloscope or probes, do not expose them to sprays,
liquids, or solvents.
Cleaning
Examine the oscilloscope and probes as often as operating conditions require. To clean
the exterior surface, perform the following steps:
1） Use a lint-free cloth to remove floating dust on the outside of the oscilloscope and
probes. Take care to avoid scratching the glabrous display filter.
2） Use a soft cloth dampened with water to clean the oscilloscope. For more efficient
cleaning, you may use an aqueous solution of 75% isopropyl alcohol.
Note: To avoid damage to the surface of the oscilloscope or probes, do not use any
corrosive or chemical cleaning agents.
To Next Page
Loading...
Need help?
General
