Hantek Hantek2000 Series User Manual

Utility
Press Menu button to enter.
Utility Menu Table
Menu
Setting
Description
Language
中文
English
Set the menu language.
Sound
On
Off
Open the key sound.
Close the key sound.
Backlight
luminance
1~10
Set backlight brightness of the screen.
Backlight
time
30s
60s
90s
120s
Unlimited
Set the screen backlight time.
System
information
Display system information, such as software
version or PCB version.
Automatic
shutdown
5 Minute
10 Minute
20 Minute
30 Minute
Unlimited
Set automatic shutdown time.
Calibration
Start
Return
Start the self calibration.
Exit the self calibration.
Note:
1. Backlight time and automatic shutdown time will not be executed when the
oscilloscope is plugged in with an external charging device or connected to a
computer via a USB cable.
2. Shutdown automatically saves last setup.
Self calibration
The self calibration routine helps optimize the oscilloscope signal path for maximum
measurement accuracy. You can run the routine at any time but should always run it if the
ambient temperature changes by 5℃ or more. For a more accurate calibration, please
power on the oscilloscope and wait for 20 minutes until it has adequately warmed up.
To do self calibration, follow these steps:
1. Ensure that no input signal is input, otherwise it may damage the instrument.
2. Press Menu button to select the self calibration function.
Update
Connect the oscilloscope to the computer with USB cable. Press the F1 button and the

Hantek Hantek2000 Series Specifications

General

Brand	Hantek
Model	Hantek2000 Series
Category	Measuring Instruments
Language	English