SHIPPING BRACKETS
- CAUTION -
DO NOT attempt to move the machine axes until the shipping brackets have been
removed.
- NOTE -
The shipping brackets are painted RED for easy identification.
DO NOT discard the shipping brackets or mounting hardware. The brackets must
be installed whenever the machine is to be moved.
T-51 and T-65 lathes shipped in containers have the control pendant mounted at
the right end of the machine during shipment. Information on mounting the control
pendant in operating position begins on page 1-15.
SHIPPING BRACKET LOCATIONS
•
Control pendant (Refer to note above)
•
Guard door (T-51 and T-65 lathes only)
•
Left and right front corners of coolant guard (T-51 and T-65 lathes only)
•
Left end of power case platform (Viewed from back of machine)
•
Machine carriage
1-8 M-507C
To Next Page
Loading...
