CLEANING THE MACHINE
- CAUTION -
Do not use compressed air to clean the machine. Air pressure forces dirt and
other foreign matter past the seals and covers into the slides, ball screws, and
bearings. This causes additional wear and will reduce the life and accuracy of the
machine.
After the machine has been properly located, remove all shipping grease, oil, and dirt accumulated
in transit. USE A CLOTH OR BRUSH WITH A GOOD GRADE OF PETROLEUM BASE GREASE
SOLVENT TO CLEAN THE MACHINE.
Use Clorox 409
®
cleaner with a soft, clean, lint-free cloth to clean the guard door vision panel. Do
not use benzene, leaded gasoline, acetone or chlorinated solvents.
1-18 M-507C
To Next Page
Loading...
