Hardinge T-51 - CHAPTER 2 - EXTENDED STORAGE; Battery Maintenance for Storage; Lubrication and Rust Prevention; System Cleaning for Storage

Hydraulic System .................................... 1-39
Hydraulic Tank Fluid Capacity ............................ 1-39
Filling the Hydraulic Tank .............................. 1-39
Foot Switch Installation ................................. 1-40
Option Interface Receptacles .............................. 1-41
Non-Metallic Materials Typically Found in Hardinge Machine Construction.......1-41
CHAPTER 2 - EXTENDED STORAGE
Battery Maintenance ................................... 2-1
Control Battery .................................... 2-1
Axis Drive Batteries .................................. 2-3
Lubrication ........................................ 2-5
Lubrication Procedure................................. 2-6
Apply Rust Inhibitor .................................... 2-8
Clean the Spindle(s) ................................... 2-8
Clean the Air Filter Bowls ................................ 2-11
Coolant System ..................................... 2-12
Clean the Coolant Filter ............................... 2-12
Clean the Coolant Tank ............................... 2-13
Clean the Main Spindle Coolant Catcher ...................... 2-20
Hydraulic System .................................... 2-21
Spindle Chiller ...................................... 2-23
Coolant Chiller...................................... 2-25
Removing the Machine Hold-Down Brackets ...................... 2-26
Shipping Restraints ................................... 2-27
Install the Shipping Tubes .............................. 2-27
Install the Shipping Brackets............................. 2-29
Electrical and Air Supplies................................ 2-33
Electrical Lockout .................................. 2-33
Air Lockout...................................... 2-33
DOCUMENT REVISION RECORD
ii M-507C