MA310 | MA510 | MA710 Owner's Manual | rev1.3 20240612
Pg 21 of 42
©2024 Harman International | Features, Specifications, and Appearance subject to change without notice.
Setup Menus
The Setup menus allow you to configure all aspects of your Receiver. The next few pages will go through the menu items
accessible via the front panel or IR remote and explain their function. Most of the Setup menus need only be configured once
when you first install the system (or if your system changes, you move any large furniture or the listening locations, or you
move).
ENTERING SETUP MODE
To enter the setup menu, press the MENU button on the remote control or font panel. We recommend you use the OSD (On-
Screen Display) on your TV whenever possible. Alternatively, the front panel display shows the setup menu one line at a time.
NAVIGATING THE SETUP MENU
…using the remote control
The setup menu can be navigated by using the cursor (arrow) keys on the remote control. This is by far the easiest method.
1. To enter the setup menu, press the MENU button (which is located immediately under the navigation buttons).
2. Use the and keys to navigate left and right the main menu section headings.
3. Once you have the main section that you require highlighted, use the SELECT key to enter the section.
4. Use the and keys to navigate up and down the section settings. Some settings may be greyed out. These are either
for information only (e.g. incoming sampling frequency) or are not currently selectable. Page numbers on the bottom right
of the OSD menu indicate your position in the settings list where there are more items than can be displayed at once.
5. Pressing SELECT chooses a setting to change it, pressing SELECT again or BACK de-selects the setting.
6. At any time, press the MENU button to exit the menu. Any changes to settings are saved.
…using the keys on the front panel
The Receiver front panel controls can be used to configure the unit. Follow the instructions for using the remote control, in this
case using the Input rotary knob for up, down, left and right. Press the Input button to select.
To Next Page
Loading...