MA310 | MA510 | MA710 Owner's Manual | rev1.3 20240612
Pg 25 of 42
©2024 Harman International | Features, Specifications, and Appearance subject to change without notice.
SYSTEM SETUP
General Setup
– General information and system controls
Max On Volume - Limits the maximum volume the system operates in the main zone when it is switched on or comes
out of Standby. The system comes on at this stored volume setting if the last used (possibly very loud) volume exceeds
this value. It is stored in memory and recalled each time the unit is powered up.
Display On Time - Sets the time that the front panel display remains illuminated after receiving a command. The
default is always on.
Power Mode – Determines how the unit powers on in Standby mode.
Green
Bluetooth Off,
Any activity associated with network streaming or Bluetooth are disabled.
Low Power
NET On,
Bluetooth On,
HDMI Off
Network and Bluetooth activities remain On. System will transition from
Standby to On by any activity derived from Streaming services, app control
and/or Bluetooth.
HDMI Pass Through
NET On,
Bluetooth On,
HDMI On
Enables the unit to pass-through any video connected to last source, as
applicable, the rest of the features connected to Low power standby mode
remain.
Language - Select the language for the setup menu - English, French, Spanish, Portugues, Korean, Japanese,
Simplified Chinese.
HDMI
Settings - The settings in this menu control the HDMI behavior for control and audio. These settings are applied to all
video inputs and are stored in memory and recalled each time the unit is powered up.
HDMI CEC - Selects if CEC control is enabled on HDMI output.
Audio to TV - This setting controls the audio being sent direct to the TV.
Mini OSD Pop-Up - Selects whether the pop-up OSD messages are On or Off.
On
All user adjustments that are made during the general use of the Receiver are displayed on
screen as well as the front panel display. This includes the adjustment of volume, mute,
input source, and surround mode.
Off
The above user adjustments will not appear on screen, only on the front panel display. This
leaves the picture on your display device clear of pop-up text. However, regardless of this
setting the Setup menus are always displayed on screen.
Assign Video In - Settings to optionally assign a video source to each of the normally audio-only inputs. These settings are
stored in memory and recalled each time the unit is powered up.
The default for each of the audio-only inputs is ‘None’. You could, however, associate HDMI video with NET internet radio audio
to receive radio commentary of a sports game with pictures from cable coverage, for example.
To Next Page
Loading...