Pg 8 of 14
©2024 Harman International | Features, Specifications, and Appearance subject to change without notice.
Calibrating the system with EZ Set EQ
The EZ Set EQ app will automatically try to establish a connection with the AVR.
If the auto-connect fails:
MA310
Confirm the mobile device has successfully paired via Bluetooth to the AVR via and that Bluetooth is selected as the input
source.
MA510, MA710, MA7100HP, MA9100HP
Confirm that the mobile device and the AVR are connected to the same network. Check that the IP address of the AVR is on
the same subnet in network settings. You can confirm this by navigating to Menu > Setup > Network Status > Status.
USUNG SUBWOOFERS
If your system includes active subwoofers, you may need to set the subwoofer output level/gain control set to a higher or lower
value.
EZ Set EQ does not calibrate the subwoofer separate from the main loudspeakers. The system is calibrated full-range with the
subwoofer output active to capture the “system” acoustic data to blend the subwoofer more effectively for each channel. In this
way, the system takes a snapshot of the combined performance of the loudspeaker and subwoofer system integration.
You may ask - “What if I want to listen to traditional 2-channel Stereo without a subwoofer?”
EZ Set EQ allows correction of the Front Left and Right loudspeakers both with and without a subwoofer. In this case, you will
take two measurements of the Front Left and Right loudspeakers, labelled as Front (Small) and Front (Large). The system will
automatically select the Front (Large) calibration any time you change the surround mode to Stereo 2.0 for optimized full-
range 2-channel performance without a subwoofer.
Full-range calibration with subwoofer
and the chosen crossover
Full-range calibration without subwoofer
To Next Page
Loading...