888-2406-002 2-23
WARNING: Disconnect primary power prior to servicing.
Installation & Initial Turn-On
2.7 Remote Control Connections
The Platinum Z2 Transmitter may be operated by remote control by connecting a
remote control system. If the transmitter is to be remotely controlled, it is important
to initiate thorough routine inspection and maintenance procedures at the
transmitter location. Installation of equipment to monitor temperature and humidity
at the remote transmitter site is also recommended.
Terminations provided in the Platinum Z2 Transmitter allow remote control of the
transmitter functions by connection to terminals on TB1 (Terminal Board 1). TB1 is
a 38 pin Terminal strip with a D-connector on the back which connects to J20 on the
controller Backplane/Display Board. Tables 2-1 and 2-2 contain a complete listing
and explanation of connections for TB1. Figure 2-11 shows TB1 pinout and
connections. TB1 is located in the upper left side in the rear of the transmitter when
viewing from the back. Use shielded cable for the remote control lines and/or install
it in a metal conduit. It is acceptable to install it in the same conduit as the exciter
input cables.
Figure 2-11 TB1 Customer Interface Connections
To Next Page
Loading...
