888-2406-002 2-25
WARNING: Disconnect primary power prior to servicing.
Installation & Initial Turn-On
NOTE:
Maximum status line current is 25 mA. If the output is used to drive a small
printed circuit board type relay, check current requirements for relay coil and
be sure to install a circuit protection diode across the coil. A 1N4004 or
equivalent will work.
2.7.1.1 Typical remote/extended control and status connections
Figure 2-14 shows typical remote/extended control and status connections.
Figure 2-14 Remote/Extended Control and Status Connections
To Next Page
Loading...
