3-8 888-2406-002
WARNING: Disconnect primary power prior to servicing.
Operator Guide
Example 2
You want to check or possibly change the Maximum High Power Setting. This falls
under the category of CONFIGURATION, but this menu item only shows up on the
second screen of the HOME layer. Therefore, press the following keys:
[HOME, MORE, CONFIGURATION B,B]
This should have taken you to the screen shown in Figure 3-7. This screen now
allows the operator to change the Maximum High Power setting using the A,B,C
and D function keys. Pressing the BACK key updates the change, while pressing
HOME would cancel any changes.
Figure 3-7 Max High Power Configuration Screen
[HOME, MORE, CONFIGURATION B,B]
3.4.5 Asterisk and Pound Signs(*, #)
The asterisk and the pound sign characters are used in some of the metering menus
of the Diagnostics Display. If an asterisk (*) shows up in a metering menu, it means
that there is no data being received for that reading. The pound sign will only be
used in the Vg (Gate Control Voltage for the individual PAs) menus and signifies
that there has been a crossover (this is a condition where one PA Controller crosses
over and mutes the PAs associated with another PA Controller).
To Next Page
Loading...
