Maintenance 1B20, 1B27, 1B30, 1B40, 1B50
72
HATZ
Operator's Manual
Step Activity Figure
5 Also clean the cooling ribs of
the cylinder head (3) and cylin-
der (4) and blow out with com-
pressed air.
6 Check the air gap (5) for dirt
and clean with compressed air
if necessary.
Note:
In 1B20 and 1B27, the air gap
(5) is markedly smaller than
the gap shown in the figure
(size approx. 5 mm).
7 The element can be checked
and cleaned through the holes
in the contact guard.
8 Mount the recoil start (2)
again.
Moist or oily contamination
1 Contact the HATZ service sta-
tion.
To Next Page
Loading...
