3-4L43C, 3-4M43, 3-4M43Z Operation and use
HATZ
39Manual
Step Activity
2 When the pre glow display (3) lights up, wait until it goes out
then continue with step 3
3 Turn the starting key to position "II".
4 As soon as the engine is running, release the starting key.
▪ The starting key springs back to position "I" and remains in
this position during operation.
▪ The charge control (5) and oil pressure display (6) go out.
▪ The operating display(4) lights up.
NOTICE
▪ In case of irregularities, switch off the engine immediately.
▪ Identify the fault and eliminate it.
▪ For details of troubleshooting, see chapter 9.1 Trouble
shooting, page 88.
NOTICE
▪ If the engine stops again immediately after starting, or stops
independently during operation, this is an indication that a
monitoring element of the automatic shutoff has been acti-
vated.
▪ Remedy the fault before making further starting attempts
(see chapter 9.1 Trouble shooting, page 88).
▪ Despite the automatic switch-off, check the oil level every
8–15 operating hours (see chapter 7.8 Checking the oil level
and adding oil if necessary, page 43).
7.5 Switching off the engine
Safety note
CAUTION
Danger of injury from unauthorized access.
There is a danger of injury if unauthorized persons handle the
machine.
▪ Protect the starting key against unauthorized access during
breaks in operation or after completing work.
To Next Page
Loading...
Need help?
General
