Hatz M Series - 7.8 Checking and Adding Engine Oil

3-4L43C, 3-4M43, 3-4M43Z Operation and use
HATZ
43Manual
Procedure
Step Activity
1 Place a suitable container under the drain plug (1).
NOTE: In inaccessible locations, an extension hose can be
mounted on the drain screw (1).
2 Open the drain screw (1) and drain the water into the container.
3 If not enough liquid escapes, undo additional screw (2).
4 As soon as fuel escapes, close the drain plug (1) and screw (2).
NOTE: First water escapes then fuel. This can be seen by a
clear separator.
5 Dispose of the water/fuel mixture in accordance with the local
environmental regulations.
NOTICE
i
Note - If starting difficulties occur:
Bleed the injection system with the aid of the manual fuel pump
with the aid of the injection system (see chapter 7.3.1 Pumping
fuel with the manual fuel pump, page 34).
7.8 Checking the oil level and adding oil if necessary
Safety notes
CAUTION
Danger of burns.
There is a danger of burns when working on a hot engine.
▪ Wear safety gloves.
CAUTION
Danger of injury
Prolonged contact with engine oil can lead to irritation of the
skin.
▪ Wear safety gloves.
▪ If there is contact with the skin, thoroughly wash the af-
fected areas of the skin with soap and water.