107
4000715370
E 06.18 - V2
USA / GB
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
D
- Operation instructions
5 - Transportation
5.1 - PUTTING IN TRANSPORT POSITION
During loading, ensure that :
• The loading ramp can support the machine weight.
• The loading ramp is correctly attached to transport vehicle.
• The loading ramp has sufficient grip surface.
• The transport vehicle must be parked on a level surface and must be secured to prevent rolling away
while machine is being loaded or unloaded.
Do not place yourself below or too close to the machine during loading.
The machine must be completely in the stowed configuration :
• Check the platform is completely empty.
To climb the slope, select low driving speed.
If the slope is too steep, use a winch in addition to the low speed drive.
• Raise the jib to maintain ground clearance when driving the machine onto a loading ramp.
• Lower the boom.
• Ensure that the jib is raised as necessary to give ground clearance when driving the machine onto the
loading ramp.
• Drive onto the truck bed slowly.
• Secure the machine to the tie down points provided (Section D-Machine layout).
• Lock the turntable with the rotation stop pin located under the turntable before transporting (Section
D-Machine layout).
• The platform/basket must be chocked and the boom strapped to prevent bouncing up and down, thus
preventing possible material damage during transporting.
• Do not use excessive downward force when securing boom section.
A wrong move can lead to machine tipping over and may cause serious injuries and material damage.
To Next Page
Loading...
