12 4000715370
E 06.18 - V2
USA / GB
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
A
- Foreword
2.1.3 - Overturning / Tip-over Hazards
Before positioning and operating the machine :
• Ensure that the surface is capable of supporting the machine weight
including the rated capacity. Check the load bearing capacity of the
supporting ground.
• Remain vigilant of driving direction reversal at the platform. Check the
driving direction with the help of the red or green arrow on the chassis
relative to the red and green arrows on the platform control box.
• Do not exceed the maximum rated capacity that includes the weight of both
material and allowed number of occupants. Do not exceed the allowable
number of occupants.
• Place the loads uniformly distributed on the platform floor.
• Do not increase the working height (using extensions, ladder, etc.).
• Do not place ladders or scaffolds in the platform or against any part of this
machine.
• Do not use the machine in winds exceeding the permissible limit.
• Do not increase the surface area of the platform exposed to wind. This
includes adding panels, mesh, banners. Be aware when working with
materials with a large surface area. This will add to the wind load on the
machine.
• Do not raise the platform or drive with platform elevated on an incline
exceeding the rated slope for the machine.
• Do not drive the machine on slopes or grades exceeding the specified
limits.
• Do not replace components critical to stability with components of different
weight or specification.
• Do not use the machine with material or objects hanging from the guardrail
or the boom.
• Do not pull or push towards any object outside of the platform. Do not
exceed the maximum allowable side force stated in the performance
specifications.
• Do not use the machine to support any external structure.
• Do not use the machine to tow other machines or to drag materials.
To Next Page
Loading...
