88 4000715370
E 06.18 - V2
USA / GB
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
C
- Pre-operation inspection
4 - Safety functional checks
To protect the user and the machine, safety systems prevent the movement of the machine beyond its
operating limits. These safety systems when activated immobilize the machine and prevent further
movement.
The operator must be familiar with this technology and understand that is not a malfunction but an
indication that the machine has reached an operation limit.
Aerial Work platforms are equipped with two control boxes which allow operators to safely use the
machine. An auxiliary device (overriding system) is available on ground control box when primary
power source fails. Each control box is equipped with an E-Stop button, which cuts all movements
when pushed in.
The following checks describe the operation of the machine and the specific controls required.
For the location and description of these controls : refer to section B 3.2 and D 2 - Ground control
box and B 3.3 and D 3 - Platform control box.
4.1 - E-STOP BUTTON CHECK
Ground control box E-stop button
Platform control box E-stop button
Step Action
1 Pull the E-Stop button ( 9 ) at the ground control box.
2
Set the key switch ( 22 ) at ground box to the position
3 The indicator ( 10 ) lights up on ground control box
4 Start the engine by pressing the engine start-up selector ( 16 ) .
5 Push in the E-stop button ( 9 ).
6 Check that the engine stops running.
7 Check no movements are functional.
Step Action
1 Pull the E-Stop button ( 9 ) at the ground control box.
2
Set the key switch ( 22 ) at ground box to the position
3 The indicator ( 13 ) lights up on ground display panel
4 Pull out the E-Stop button ( 46 ) at platform box.
5 Start the engine from platform using Start/Stop switch ( 230 ).
6 Push in E-Stop button ( 46 ) at platform.
7 Check that the engine stops running.
8 Check no movements are functional.
To Next Page
Loading...
