Haulotte HA20RTJ - Page 13

A
B
C
D
E
F
G
H
I
13
4000715370
E 06.18 - V2
USA / GB
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
A - Foreword
Using a machine on a slope :
• If the tilt alarm sounds when uphill with the platform raised, follow the sequence :
• Retract upper boom.
• Lower the arm.
• Lower the upper boom.
• If the tilt alarm sounds when downhill with the platform raised, follow the sequence :
• Lower the upper boom.
• Lower the arm.
• Retract upper boom.
• While driving, always place the boom above the rear axle, in the direction of movement.
• While driving on a slope:
• Always orientate the machine in the direction of the slope.
• Always place the boom in fully retracted and in stowed position.
• Do not travel down slopes in high speed.
• Do not drive fast in narrow or cluttered areas. Keep speed under control while making turns or sharp bends.
WIND : The aerial work platform can operate up to a maximum wind speed as indicated in the
specifications. To identify the local wind speed, use the Beaufort scale below, use a wind
gauge or an anemometer.
Do not exceed the slope limit for each operation. Section B 4.1 - Technical specifications.
Slope :
• Driving in transport position on an upward or downward slope.
Sideslope :
• Driving in stowed position across a slope.
Rated slope :
• Operating with platform elevated.