Need help?Do you have a question about the HBM VK20A and is the answer not in the manual?
Describes the intended use of the junction box and general care requirements for safe operation.
Highlights risks from improper use by untrained personnel and the need to understand the manual.
Discusses the scope of the junction box and the need for safety engineering in the overall connection technique.
Defines qualified personnel and emphasizes adherence to specifications and safety regulations.
Specifies the need to protect the junction box from dirt and humidity.
Details IP65 protection and the requirement for regular checks of seals and fittings.
States that prevailing accident prevention regulations must be observed.
Prohibits modifications without HBM consent and clarifies HBM's non-liability for damage.
Explains how important safety instructions are identified within the document using specific markings.
Details the CE mark and statutory marking requirements for waste disposal found on the product.
Provides detailed physical dimensions of the VK20A junction box in millimeters and inches.
Illustrates the internal connection clamps within the opened VK20A junction box.
Lists and illustrates HBM connector cables (1-Kab 151-1.5 and 1-Kab 152-1.5) for connecting to evaluation electronics.
Explains the use of cable sleeves and PG7 screwed joints for connecting transducer cables and power supply.
Provides a detailed pin assignment table for connecting T20WN and T21WN transducers to terminals St1 and St2.
Details the pin assignment for connecting the T22 transducer to terminals St1 and St2.
Outlines the pin assignment for the voltage supply input (St7) including voltage and control signal connections.
Details the pin assignment for the voltage torque output (Md [V]) using connector assignments St3 and St4.
Details the pin assignment for the current torque output (Md [I]) using connector assignment St8.
Provides pin assignments for speed/angle of rotation outputs (n/) using connector assignments St5 and St6.
Explains the integrated control diodes and push button for checking wiring and triggering control signals.
Describes methods to trigger a control signal, including using the onboard push button or external signals.
To Next Page
General