HBS C 08 - Change Working Place

C 08 Order No. BA 92-20-262 Issue 01.03.08 17
 Connect the ground clamps to the workpiece as securely as possible.
Take care to ensure good contact and symmetrical connec-
tion. The welding location must lie directly between the two
ground clamps.
3.4 Change Working Place
Switch off the power unit. In this way, you avoid any risk of
electrical shock.
 When you move your workplace, disconnect the welding gun and the ground
cables from the power unit. Proceed in reversed sequence as described in
section 3.2 and 3.3.
 After changing the workplace, check the welding gun and the ground cables for
possible damage or missing components.
3 Starting-up
3.4 Change Working Place