HBS C 08 - Page 58

58 C 08 Order No. BA 92-20-262 Issue 01.03.08
I
ignition tip ......................................25, 34
intended use ................................... 7, 10
internal thread sleeve IT ....................... 34
ISO-clip ............................................... 35
ISO-nail ............................................... 35
IT, pin with internal thread ....... 27, 34, 52
L
liability, any ............................ 10, 24, 53
liquid spatters ...................................... 28
liquids, combustible ............................. 14
lot ........................................................ 34
M
magnetic fields ..............................14, 24
maintenance .......................................... 7
maintenance instruction,
company specific ........................... 7
maintenance operation ........................ 37
malfunction ............................................ 7
malfunction and corrective actions ...30, 33
markings .......................................12, 38
material combinations ...................27, 52
material of the welding element ........... 26
material of the workpiece ..................... 26
materials, rapidly oxidizing .................. 25
metal spatters ..................................... 23
N
noise damping tube ............................. 44
non-combustible clothes ...................... 23
O
operating manual ............................ 7, 13
operating manual, storage of ................. 7
operation, improper .............................. 28
operators ............................................... 7
order number ....................................... 40
P
pace maker .............................. 9, 15, 24
personnel .............................................. 7
pin UT ................................................. 34
pin with internal thread IT ..................... 34
pipes, welding to ................................. 26
place of operation ................................ 10
plastic housing .................................... 18
plunging speed ..............................21, 25
positioning tube ................................... 44
power unit ......................................10, 49
prestress at installation ................. 27, 52
protection class .............................14, 39
protective apron ................................... 23
protective equipment ......................15, 24
protective equipment, personal .............. 7
protective gloves .................................. 23
protective goggles .................................. 7
PT, threaded stud ................... 27, 34, 52
punched plates, welding to .................. 26
Q
quality of the weld, check the .............. 29
R
rectifier ................................................ 49
recycling ............................................. 48
regular maintenance operations ........... 38
regulations ........................................... 50
repair ................................................... 48
requirements of workplace ................... 14
retaining nut ..................................16, 19
risk of material damage ......................... 9
risk of personal injury ............................ 9
room, adequately ventilated ................. 23
room level ............................................ 23
rooms, confined ...................... 14, 22, 23
rooms, exposed to risk of explosion .... 14
S
safety instructions .................... 7, 22, 37
safety symbols .................................... 12
safety symbols, means of ..................... 9
serial number ................................18, 53
service ................................................... 7
service & support ................................. 56
service technician .................................. 7
set-up .................................................... 7
shoes .................................................... 7
spare parts, ordering of ..................40, 53
special welding elements ..................... 35
spring force ......................................... 26
spring force adjustment .................18, 21
standards ............................................ 50
standards, actual ...........................10, 28
Index