17©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
8 Design and Function
8 Design and Function
The body of the stud welding gun consists of a sturdy two-part plastic housing (2).
The control cable and the welding cable (3) are connected through the welding
gun handle to the welding gun.
At the front of the welding gun handle, the welding gun trigger (4) is installed. It is
used to trigger the welding process.
At the front of the welding gun, the foot ring is installed. Three legs (5) can be used
to position the welding gun straight.
Positioned at the front of the welding gun are the welding piston and the retaining
nut (6) used to x the manual chuck.
At the rear, there is the mechanism for lift adjustment (8), rotating graduated
ring (7) and for spring force adjustment (1).
The serial number (9) can be found on the welding gun handle.
Type plate
The type plate contains the following information:
– Manufacturer
– Type
The serial number is stamped.
To Next Page
Loading...
