HBS CA 08 - Preparing the Welding Gun; Adjusting the Chuck

19©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
10 Preparing the Welding Gun
10 Preparing the Welding Gun
Prepare the welding gun by
– adjusting the chuck
– mounting the chuck
– adjusting lift and spring force.
 Do not connect the gun to the stud welding unit until it has been
prepared.
In this way you can avoid any unintentional starting of the welding process.
10.1 Adjusting the Chuck
 Select a chuck suitable for your welding element.
for CD stud welding:
Threaded studs PT and PS
Stud dimension Chuck
Ø d
1
Length in mm
M3 6 - 30 mm 82-50-003
M4 6 - 40 mm 82-50-004
M5 8 - 45 mm 82-50-005
M6 8 - 55 mm 82-50-006
M8 10 - 40 mm 82-50-008
Pins UT and US
Stud dimension Chuck
Ø d
1
Länge
3 6 - 25 mm 82-50-003
4 6 - 25 mm 82-50-004
5 6 - 40 mm 82-50-005
6 8 - 50 mm 82-50-006
7,1 10 - 40 mm 82-50-071
Pins IT and IS
Stud dimension Internal
thread
Chuck for studs with internal thread
Ø d
1
Länge
5 6 - 35 mm M3 82-50-905
6 8 - 35 mm M4 82-50-906
6 8 - 35 mm M5 82-50-906
7,1 10 - 35 mm M5 82-50-971
8 10 - 35 mm M6 82-50-908