HBS Visar 650 - Performing the Welding Process

39©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
12 Welding
12.4 Performing the Welding Process
 First set the necessary welding parameters.
 Read and observe here point 12.3 „Setting the Welding Parameters“.
Electric shock and electric arc hazard
 Never touch the welding elements, chuck, retaining nut or electrically con-
ductive parts in their vicinity during the welding process.
These parts are live.
 Never wear metal jewellery, even a wristwatch, on your body during the
welding process.
This will help to avoid injuries and damage due to electric power or electro-
magnetic elds.
Electric shock and electric arc hazard
 Stand on an insulated mat if you have to weld under the following condi-
tions:
– In conned spaces with electrically conductive walls
– Under cramped conditions between or against electrically conductive
parts
– Where there is limited mobility on electrically conductive parts
– In damp, wet or hot rooms.