HBS Visar 650 - Carrying out Bending Test

©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
44
13 Checking the Quality of the Weld
13.2 Carrying out Bending Test
You can purchase from HBS a bending device with inserts for various diameters of
the welding elements.
The bending test serves as an easy work sample and as a check for the selected
welding parameters. The welded joint is stressed by bending in a non-dened way.
1 - Welding element
2 - Welded joint
 Place the bending device on the welding ele-
ment (1) and
 bend the welding element (1) with the bending de-
vice once by 60° in any direction.
The bending test is passed if a crack or a fracture of the
welded zone does not occur.
 Further tests should be conducted if the connection fails in the weld
area.
 In this case, bend the welding element exactly in the opposite direction by
60° towards the failing seam.
For a non-destructive strength test of the welding elements HBS offers a
torque bending test device in accordance with DIN EN ISO 14555 (Order No.
92-40-135A).