HDFury Vertex2 - Page 47

Disclaimer: 3
rd
party and/or custom firmware providing extra features are not covered in this manual.
47
4K Vertex² – User Manual
#vertex2 set edid audio x
where x is [stereo / 51 / full / native / tx1]
Sets the automix EDID audio flag
Ex. #vertex2 set edid audio native
#vertex2 set edid bt2020 x
where x is [on / off]
Sets the automix EDID bt2020 capability addition
Will not remove if existing on the sink - only adds if missing
Ex. #vertex2 set edid bt2020 on
#vertex2 set edid yuvremove x
where x is [on / off]
Sets the automix EDID YUV/YCbCr capability force
Controls if the source sees a YCbCr capable sink
Ex. #vertex2 set edid yuvremove on
#vertex2 set edid hdr10 x
where x is [on / off]
Sets the automix EDID hdr10 capability
Will not remove if existing on the sink - only adds if missing
Ex. #vertex2 set edid hdr10 on
#vertex2 set edid hlg x
where x is [on / off]
Sets the automix EDID hlg capability
Will not remove if existing on the sink - only adds if missing
Ex. #vertex2 set edid hlg on
#vertex2 set edid dv x
where x is [on / off]
Sets the automix EDID Dolby Vision capability
Will not remove if existing on the sink - only adds if missing
Ex. #vertex2 set edid dv on
#vertex2 set edid dvremove x
where x is [on / off]
Sets the automix EDID to remove DV capability
Ex. #vertex2 set edid dvremove on
#vertex2 set edid dvlimit x
where x is [on / off]
Sets the automix EDID Dolby Vision frequency capability to 300Mhz max
Ex. #vertex2 set edid dvlimit on