Disclaimer: 3
rd
party and/or custom firmware providing extra features are not covered in this manual.
#vertex2 set edid 3dremove x
where x is [on / off]
Sets the automix EDID to remove 3D capability
Controls if the source sees a 3D capable sink
Ex. #vertex2 set edid 3dremove on
#vertex2 set hdcp x
where x is [14 / auto]
Sets the hdcp level
in auto mode, depending on sink capability uses hdcp 1.4 or 2.2
Ex. #vertex2 set hdcp auto
#vertex2 set scale x
where x is [auto / custom / none]
Sets the scaling style for tx0 (tx1 is always automatic)
In auto mode, optimizes according to the best sink capabilities
Ex. #vertex2 set scale auto
#vertex2 set autonoupscale x
where x is [on / off]
Sets the mode for upscaling in tx0 output. Applies in "scale auto" mode only.
In "scale auto" mode enables/disables upscaling of 1080p content automatically to 4k.
Ex. #vertex2 set autonoupscale off
#vertex2 set edidtableinp0 x
#vertex2 set edidtableinp1 x
#vertex2 set edidtableinp2 x
#vertex2 set edidtableinp3 x
where x is [1 - 100] for edidtableinp0 and [0 - 100] for others
Sets the custom EDID for corresponding input port
For ports 1-3 table number 0 indicates copy port 0 table
Ex. #vertex2 set edidtableinp0 11
#vertex2 set edidalgo x
where x is [0 - 4]
Sets the automix algorithm
0 = Min video, min audio
1 = Min video, max audio
2 = Tx0 priority
3 = Tx1 priority
4 = Max video, max audio [default]
To Next Page
Loading...
