HDFury Vertex2 - Page 49

Disclaimer: 3
rd
party and/or custom firmware providing extra features are not covered in this manual.
49
4K Vertex² – User Manual
Ex. #vertex2 set edidalgo 4
#vertex2 set hdrcustom x
where x is [on / off]
Starts to output custom HDR metadata and ignores any input received HDR metadata.
Overrides all other hdrcustom options
Ex. #vertex2 set hdrcustom on
#vertex2 set hdrcustomhdr10only x
where x is [on / off]
Starts to output custom HDR metadata if and only if the input is HDR10.
This setting is used to replace the incoming HDR10 metadata.
Ex. #vertex2 set hdrcustomhdr10only on
#vertex2 set hdrcustomhlgonly x
where x is [on / off]
Starts to output custom HDR metadata if and only if the input is HLG.
This setting is used to replace the incoming HLG metadata.
Ex. #vertex2 set hdrcustomhlgonly on
#vertex2 set hdrcustomhlgonlyauto x
where x is [on / off]
Starts to output custom HDR metadata if and only if the input is HLG
and the sink has no HLG support.
This setting is used to replace the incoming HLG metadata.
Useful when turning on/off HLG capable sink while non-HLG sink is also connected.
Ex. #vertex2 set hdrcustomhlgonlyauto on
#vertex2 set hdrdisable x
where x is [on / off]
Stops sending any HDR metadata content
Ex. #vertex2 set hdrdisable on
#vertex2 set hdrdisablehdr10only x
where x is [on / off]
Stops sending any HDR metadata content if the input is HDR10
Ex. #vertex2 set hdrdisablehdr10only on
#vertex2 set hdrdisablehlgonly x
where x is [on / off]
Stops sending any HDR metadata content if the input is HLG
Ex. #vertex2 set hdrdisablehlgonly on