Disclaimer: 3
rd
party and/or custom firmware providing extra features are not covered in this manual.
Ex. #vertex2 set mutetx0audio on
#vertex2 set mutetx1audio x
where x is [on / off]
Mute the tx1 hdmi audio output
Ex. #vertex2 set mutetx1audio on
#vertex2 set analogvolume x
where x is [-30 to +10]
Sets the analog L/R audio jack output volume in dB.
Ex. #vertex2 set analogvolume -10
#vertex2 set analogbass x
where x is [-10 to +10]
Sets the analog L/R audio jack output bass level in dB.
Ex. #vertex2 set analogbass 5
#vertex2 set analogtreble x
where x is [-10 to +10]
Sets the analog L/R audio jack output treble level in dB.
Ex. #vertex2 set analogtreble -2
#vertex2 set reboot
Reboots the unit, does not clear any settings
#vertex2 set factoryreset x
where x is [1, 2, 3]
1 = Erase all settings but retain the custom EDID tables
2 = Erase custom EDID tables but retain other settings
3 = ERASE all settings and EDID tables
Ex. #vertex2 set factoryreset 3
#vertex2 set jvcmacro x
where x is [on / off]
Enables / disables JVC macro sending
Ex. #vertex2 set jvcmacro on
#vertex2 set jvcmacrosync x
where x is [on / off]
Enables / disables JVC macro sending on every sync instead of just at start once
Ex. #vertex2 set jvcmacrosync on
#vertex2 set jvcmacrodelay x
where x is [0 - 255]
To Next Page
Loading...
