HDG F20 - Page 43

4 Planning and installation – Installing the heating system
43
4. Hang the upper side cladding (4) into the lower side cladding and
into the two upper cladding brackets (1 + 2).
5. If necessary, hang the side cover (5) into the side cladding (4) and
fasten it at the bottom with the two drilling screws.
6. Proceed in the same manner described above for fitting the
cladding on the left side.
R
EAR CLADDING
7. Hang the lower rear cladding (4) into the base plate and into the
two bottom cladding brackets (2 + 5).
Figure 4/20 - Fitting the upper side cladding
1
5
4
2
Figure 4/21 - Installing the rear cladding
3
2
4
5
1