Heathkit HD-1250 - Final Assembly

FINAL
ASSEMBLY
Refer to Pictorial
8-1
for
the
following
steps.
(
)
Secure the right side panel
to
the chassis
with a
6-32
x
3/8"
black screw
through the side of the panel and into the chassis.
(
)
Turn the
Dip
Meter top-side-down. Then secure
the right
side panel, front
and rear, with
two
6-32 x
3/8"
black screws.
{
)
Remove the backing from
the four feet and press
the
feet
in place on the
underside of the side panels
as shown in the Pictorial. Position
each
foot
approximately
1/8"
inside of
each front and rear corner.
PICTORIAL 8-1