Heathkit HD-1250 - Oscillator Installation

OSCILLATOR INSTALLATION
Refer
to
Pictorial
6-1
(fold-out from Page
33)
for the following steps.
NOTE:
Be sure the
free
capacitor
leads still extend
straight out from the edge of
the board,
and that the
47 pF mica capacitors are flat
against the circuit
board.
( )
Apply
a small additional amount of solder
to the corners on
the
foil
side
of
the detector circuit board
as shown in Detail
6-1
A.
( )
Position
the chassis
assembly top-side-down as shown in the Pictorial.