Page
32
( )
Position the oscillator
circuit board with
the foil-side
toward you, and
with
the two braids, the 47
pF capacitor leads, and
the blue wire
toward
your right. Slide the
oscillator circuit board into
the rear of
the chassis
assembly, and
pass the two 47 pF
capacitor
leads
directly through
tuning
capacitor lugs
2 and 3 as shown. Then, press
the oscillator circuit
board to
the right as far as you can
to
shorten
the 47 pF capacitor
leads as much
as
possible. Do not
solder the capacitor leads.
Route the blue
wire under the
coil socket and under
the edge of the
detector circuit
board. NOTE: The
left edge of
the
oscillator
circuit
board should be
1/2"
from
the edge of
the chassis
as shown in Pictorial and in
Detail
6-1 B.
(
)
Refer
to Detail
6-1
B
and loop
the two lengths of
braid coming from
the
corners of
the oscillator
circuit board until
they overlap the corners
of the
detector circuit
board
as shown. Solder
each
of
these braid
ends to the
corners of the
detector circuit
board. Be sure neither
of the braids
touch
the tuning
capacitor lugs.
( )
Position
the
oscillator circuit
board
so it is vertical
and even with
the edge
of
the chassis flange
as shown
in Pictorial
6-1
.
( )
Solder
tuning capacitor
lugs
2
and
3; then cut off
any excess lead and
wire
lengths.
Refer
to
Detail
6-1 C for the next two steps.
CAUTION:
In the followng
step, be
careful that the
braid end does not
"spring"
and splash hot solder.
( )
Loop the end
of the braid
secured
by the back panel
screw over
the left
end of
the oscillator
circuit board
as shown
and solder it in
place. Be
sure
none of the
braid touches
any part of
the circuit
board other
than the
ground foil
at the
edge of the board.
Detail
6-1
C
To Next Page
Loading...
