Heathkit HD-1250 - Side Panel Assembly

Page
34
SIDE PANEL ASSEMBLY
Refer to Pictorial
6-3
for the following
steps.
(
)
Cut
a
1"
x
3-1/2"
piece
of
fiber insulator.
I
)
Remove the paper backing from the strip of fiber insulator and press the
insulator in place on the left side panel
as
shown.
<
) Cut a
3/4"
length of foam
gasket.
(
)
Remove the paper backing from
one
side of
the
3/4"
foam gasket and
press the
gasket
in
place on the bottom
portion
of the left side panel as
shown.
NOTE: When you mount the side panel in the following step, be sure not to
pinch the blue wire between the panel and the chassis.
{
)
Mount the left
side panel onto the chassis
assembly as follows: Secure the
side of the panel
with a
6-32
x
3/8"
black screw. Then,
turn the unit
top-side down and
secure the bottom of the panel with
two
6-32
x
3/8"
screws.
( )
Be sure the pushbutton
switch is
OFF
(out).
(
)
Connect
the battery to the battery connector.
(
)
Refer
to
profile
view Detail 6-3A and
push the battery into the chassis
assembly
as shown. Note that the battery fits snugly
between the strips of
foam
gasket material.
(
)
Rotate
the tuning dial back and forth several times. If the
dial rubs in
the
left panel dial slot, loosen the dial setscrew and move
the
dial
up or down
slightly, as necessary.
Then
lightly secure the screw again.
PICTORIAL
6-3