Heathkit TA-16 - Page 10

Page 8
The steps performed in
Pictorial 4 are in this
area of the circuit board.
Part number location.
START
' 111 1>
(1) 10 µfd vertical electrolytic.
Note position of (+) lead.
(J) 10 µfd vertical electrolytic.
Note position of (+) lead.
(j ) 10 µfd vertical electrolytic.
Note position of (+) lead.
("4 .47 µfd Mylar (yellow-violet-
yellow). Position capacitor body
1/4" from circuit board.
(j .47 µfd Mylar (yellow-violet-
yellow). Position capacitor body
1/4" from the circuit board.
,
( j ) LDR (#9-18). Insert the narrow-
spaced and wide-spaced leads
through the correspondingly
spaced holes in the circuit board.
( () .1 µfd Mylar (brovm-black-yel-
I low).
(j) 2500 gild tubular electrolytic.
Note position of (+) lead.
(If) Solder all connections and cut
off excess lead lengths.
PICTORIAL 4
CONTINUE
(v/) .022 µfd Mylar.
(, v ) 10 ad vertical electrolytic.
position of (+) lead.
1
ote
. ( 47 µfd Mylar (yellow-violet-
yellow). Position capacitor body
1/4" from circuit board.
(i) 100 µfd tubular electrolytic.
, Note position of (+) lead.
(1) 100 µfd tubular electrolytic.
Note position of (+) lead.
I
() 100 ilfd vertical electrolytic.
Note position of (+) lead.
( I) .22 µfd Mylar (wide red-yellow).
(1 7) .22 µfd Mylar (wide red-yellow).
(1) 2 µfd tubular electrolytic.
Note position of (+) lead.
) .1 ¡Ad Mylar (brown-black-yel-
low).
(tiç Solder all connections and cut
off excess lead lengths.
PROCEED TO PICTORIAL 5.