Heathkit TA-16 - Page 9

Page 7
The steps performed in
Pictorial 3 are in this
area of the circuit board.
START
NOTE: When installing electrolytic
capacitors, position the positive (+)
lead in the (+) marked hole in the
circuit board.
( \i 10 ad vertical electrolytic.
Note position of (+) lead.
(\,) 10 µfd vertical electrolytic.
Note position of (+) lead.
,
U) 10 µfd vertical electrolytic.
Note position of (+) lead.
. i
(V) 10 µfd vertical electrolytic.
Note position of (+) lead.
NOTE: When hookup wire is called
for, use wire of the color speci-
fied and remove 1/4" of insulation
from each end. Do not use the large
wire until it is called for later.
(i) 3-3/4" black wire. Shape the
wire along the line marked
WIRE.
i
(L/ Zener diode (#56-32). Position
the cathode end as shown.
COLOR OR COLOR OR COLOR
END DOT BAND
e
CATHODE END
1
tA 100 ¡lid vertical electrolytic.
Note position of (+) lead.
j( Solder all connections and cut off
excess lead lengths.
PICTORIAL 3
Part number location.
CONTINUE
NOTE: Mylar capacitors may be
marked with a value or with a color
code. The Mylar and disc capacitors
may be installed with their leads
in either direction.
' ( ) .022 µfd Mylar.
. (/) .22 µfd Mylar (wide red-yellow).
( ¡if .01 µfd disc. Do not use the
. 1.4 KV (1400 V) disc capacitor.
.22 µfd Mylar (wide red-yellow).
. (_, ) .22 µfd Mylar (wide red-yellow).
(.'% .22 ad Mylar (wide red-yellow).
(t,(2 µfd tubular electrolytic.
Note position of (+) lead.
( )/100 µId tubular electrolytic.
Note position of (-F) lead.
iJ') 500 µfd tubular electrolytic.
Note position of (+) lead.
(1,4 500 µfd tubular electrolytic.
Note position of (+) lead.
(-) .002 µfd disc.
Solder all connections and cut off
excess lead lengths.
PROCEED TO PICTORIAL 4.