Heatilator GCDC80 User Manual

08/04 30803 Rev X 1
INSTALLATION
& OPERATING INSTRUCTIONS
CALIBER DIRECT VENT
GCDC60/80 DECORATIVE GAS APPLIANCE
WARNING!
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual.
For assistance or additional information, consult a qualified installer, service agency or the gas supplier.
Meets All HUD Requirements for Manufactured Housing Installations.
Read these installation instructions completely before beginning installation. Failure to follow them could cause an appliance
malfunction resulting in serious injury and/or property damage.
WARNING!
DO NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and
to replace any part of the control system and any gas control which has been under water.
WARNING: If the information in this manual
is not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life.
— Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
— What to do if you smell gas
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fire department.
— Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
f i r e - p a r t s . c o m

Heatilator GCDC80 Specifications

General

Fuel Type	Natural Gas or Liquid Propane
Venting	Direct Vent
Ignition Type	Electronic Ignition
Log Material	Ceramic Fiber
Warranty	Limited Lifetime Warranty
Fireplace Type	Gas Fireplace
Efficiency	Up to 70% (NG) / Up to 72% (LP)

Summary

Location and Clearances

Appliance Locations and Space Requirements

Details required clearances around the appliance and specific location requirements for safety.

Clearances

Shows all clearances that must be maintained around the appliance.

Venting

Conversion from Top Vent to Rear Vent

Steps to convert the appliance from a top vent configuration to a rear vent.

Horizontal Termination

Details clearances and vent lengths for horizontal termination configurations.

Vertical Termination

Specifies minimum clearances and maximum vent lengths for vertical termination setups.

Wiring

Intermittent Pilot Ignition

Wiring diagram and instructions for intermittent pilot ignition systems.

Standing Pilot Ignition

Appliance Preparation

Lighting Instructions

Intermittent Pilot Ignition

Detailed steps for safely lighting the appliance with an intermittent pilot ignition system.

Standing Pilot Ignition

Detailed steps for safely lighting the appliance with a standing pilot ignition system.

Maintenance Instructions

Burner, Vent System, and Flame Checks

Limited Lifetime Warranty

Limited Lifetime Warranty

Covers component failure due to manufacturing defects for the lifetime of ownership.

1 Year Limited Warranty

Conditions, Exclusions, & Limitations of Liability

How to Obtain Service