116 2 Installation and Specifications
2.3 Software setup
U Highlight the Startup Linear choice field and press a soft key to
specify a unit of linear measure set by the ND 1200 upon startup.
Soft key selections are:
U Highlight the Startup Angular choice field and press a soft key to
specify a unit of angular measure set by the ND 1200 upon startup.
Soft key selections are:
U Highlight the Radix choice field and press a soft key to select a
Decimal or Comma radix.
Soft key Result
MM The linear unit of measure will be millimeters
Inch The linear unit of measure will be inches
Last The linear unit of measure will not be changed
Soft key Result
DD The angular unit of measure will be Decimal Degrees
DMS The angular unit of measure will be Degree Minutes
Seconds
Last The angular unit of measure will not be changed
Select a startup linear unit of measure Select a startup angular unit of measure Select a radix
To Next Page
Loading...
